How to Set Up EcoWasher® on the Washer You Already Own

Ready to set one up at home? The EcoWasher® Pro connects to your cold-water line in minutes, and the EcoWasher® SE adds an LCD and a handy spray hose.

Laundry · Setup & install

← Back home

Short answer: EcoWasher® mounts to the washer you already own — you are not swapping the whole machine. Setup is a laundry-room hookup, not a remodel.

If you searched “how to install EcoWasher” or “ozone laundry system setup,” this is the calm walkthrough: what you need, the order of steps, and what “done” looks like on a normal home washer.

What you are installing

EcoWasher® is a compact activated-oxygen unit that sits with your existing washer for chemical-free, cold-water laundry. The point of setup is simple: route cold water through EcoWasher®, then into the washer’s cold inlet, and power the unit from a normal outlet.

Still choosing a model? Skim SE vs Pro on the compare page before you mount — the hookup idea is the same; features and footprint differ — or open the EcoWasher® buyer’s guide for the full buy / compare / setup checklist.

Setup steps (homeowner checklist)

1. Pick the spot. Mount or place the cabinet where you can reach power and the cold line without stressing hoses.
2. Shut off cold water at the laundry shutoff. Relieve pressure by briefly opening the washer’s cold fill if needed.
3. Connect the cold supply → EcoWasher® → washer cold inlet with the included fittings/hoses. Hand-tight plus a gentle wrench snug — do not crush washers.
4. Plug in and power on. Confirm the unit wakes (LCD on SE, or the Pro’s ready state).
5. Open the shutoff slowly and check every joint for drips. Run a short cold fill/test cycle with no detergent.

Independent lab testing verifies EcoWasher® removes up to 100% of laundry-spread bacteria in just 5 minutes without the use of any toxic chemicals or bleach products.* Everyday loads are where the system shines once the plumbing is solid.

First-week habits

• Default to cold on tees, towels, and sheets
• Skip pouring detergent into normal loads — with EcoWasher® you never need laundry detergent again
• Spot-treat heavy grease before the wash — setup does not replace common sense on tough soils

Already installed and still weighing SE vs Pro vs EXL? The EcoWasher® buyer’s guide puts buy, compare, and setup in one place on ecoinnovations.us.

Setup questions? eco.innovations9@gmail.com

Ready to make the switch? EcoWasher® SE connects to the cold-water line of the washer you already own, and EcoWasher® Pro is worth a look if your household is a different size. Want fresher air too? The Whole-Home Kit pairs EcoWasher® SE with filter-free SafeAir™ air care.

Related reading

• Which EcoWasher® to Buy: SE vs Pro vs EXL
• What Is Ozone Laundry? A Plain-English Guide for Homeowners
• EcoWasher® SE vs Pro: Which Should You Buy?